Chapter 8
| Authentication Commands
802.1X Port Authentication
– 279 –
Authenticator Commands
dot1x intrusion-action This command sets the port’s response to a failed authentication, either to block all
traffic, or to assign all traffic for the port to a guest VLAN. Use the no form to reset
the default.
Syntax
dot1x intrusion-action {block-traffic | guest-vlan}
no dot1x intrusion-action
block-traffic - Blocks traffic on this port.
guest-vlan - Assigns the user to the Guest VLAN.
Default
block-traffic
Command Mode
Interface Configuration
Command Usage
For guest VLAN assignment to be successful, the VLAN must be configured and set
as active (see the vlan database command) and assigned as the guest VLAN for the
port (see the network-access guest-vlan command).
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#
dot1x max-reauth-req This command sets the maximum number of times that the switch sends an EAP-
request/identity frame to the client before restarting the authentication process.
Use the no form to restore the default.
Syntax
dot1x max-reauth-req count
no dot1x max-reauth-req
count – The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
To Next Page
Loading...
Need help?
General