Chapter 9
| General Security Measures
DHCPv4 Snooping
– 334 –
directly between the server and client without having to flood them to the
entire VLAN.
â—† DHCP snooping must be enabled for the DHCP Option 82 information to be
inserted into packets. When enabled, the switch will only add/remove option
82 information in incoming DCHP packets but not relay them. Packets are
processed as follows:
â–
If an incoming packet is a DHCP request packet with option 82 information,
it will modify the option 82 information according to settings specified with
ip dhcp snooping information policy command.
â–
If an incoming packet is a DHCP request packet without option 82
information, enabling the DHCP snooping information option will add
option 82 information to the packet.
â–
If an incoming packet is a DHCP reply packet with option 82 information,
enabling the DHCP snooping information option will remove option 82
information from the packet.
Example
This example enables the DHCP Snooping Information Option.
Console(config)#ip dhcp snooping information option
Console(config)#
ip dhcp snooping
information option
encode no-subtype
This command disables the use of sub-type and sub-length fields for the
circuit-ID (CID) and remote-ID (RID) in Option 82 information generated by the
switch. Use the no form to enable the use of these fields.
Syntax
[no] ip dhcp snooping information option encode no-subtype
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
See the Command Usage section under the ip dhcp snooping information option
circuit-id command for a description of how these fields are included in TR-101
syntax.
To Next Page
Loading...
Need help?
General