Chapter 10
| Access Control Lists
MAC ACLs
– 405 –
Example
This rule permits packets from any source MAC address to the destination address
00-e0-29-94-34-de where the Ethernet type is 0800.
Console(config-mac-acl)#permit any host 00-e0-29-94-34-de ethertype 0800
Console(config-mac-acl)#
Related Commands
access-list mac (400)
Time Range (186)
mac access-group
(Interface Configuration)
This command binds a MAC ACL to a port. Use the no form to remove the port.
Syntax
mac access-group acl-name {in |
out}
[time-range time-range-name] [counter]
no mac access-group acl-name {in |
out}
acl-name – Name of the ACL. (Maximum length: 32 characters)
in – Indicates that this list applies to ingress packets.
out – Indicates that this list applies to egress packets.
time-range-name - Name of the time range. (Range: 1-16 characters)
counter – Enables counter for ACL statistics.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
If an ACL is already bound to a port and you bind a different ACL to it, the switch
will replace the old binding with the new one.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#mac access-group jerry in
Console(config-if)#
Related Commands
show mac access-list (406)
Time Range (186)
To Next Page
Loading...
