Chapter 11
| Interface Commands
Interface Configuration
– 421 –
shutdown This command disables an interface. To restart a disabled interface, use the no
form.
Syntax
[no] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then re-enable it after the problem has been
resolved. You may also want to disable a port for security reasons.
Example
The following example disables port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#shutdown
Console(config-if)#
speed-duplex This command configures the speed and duplex mode of a given interface when
auto-negotiation is disabled. Use the no form to restore the default.
Syntax
speed-duplex {100full | 100half | 10full | 10half}
no speed-duplex
100full - Forces 100 Mbps full-duplex operation
100half - Forces 100 Mbps half-duplex operation
10full - Forces 10 Mbps full-duplex operation
10half - Forces 10 Mbps half-duplex operation
Default Setting
◆ Auto-negotiation is enabled by default.
◆ When auto-negotiation is disabled, the default speed-duplex setting is 100full
for 1000BASE-T ports
Command Mode
Interface Configuration (Ethernet, Port Channel)
To Next Page
Loading...
