Chapter 24
| Multicast Filtering Commands
IGMP Filtering and Throttling
– 688 –
show ip igmp
authentication
This command displays the interface settings for IGMP authentication.
Syntax
show ip igmp authentication interface [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Using this command without specifying an interface displays information for all
interfaces.
Example
Console#show ip igmp authentication
Ethernet 1/1: Enabled
Ethernet 1/2: Enabled
Ethernet 1/3: Enabled
.
.
.
Ethernet 1/27: Enabled
Ethernet 1/28: Enabled
Console#
show ip igmp filter This command displays the global and interface settings for IGMP filtering.
Syntax
show ip igmp filter [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
None
To Next Page
Loading...
