Chapter 5
| VLAN Configuration
IEEE 802.1Q VLANs
– 167 –
◆ Remote VLAN – Reserves this VLAN for RSPAN (see “Configuring Remote Port
Mirroring” on page 124).
Modify
◆ VLAN ID – ID of configured VLAN (1-4094).
◆ VLAN Name – Name of the VLAN (1 to 32 characters).
◆ Status – Enables or disables the specified VLAN.
◆ L3 Interface – Sets the interface to support Layer 3 configuration, and reserves
memory space required to maintain additional information about this interface
type. This parameter must be enabled before you can assign an IP address to a
VLAN (see “Setting the Switch’s IP Address (IP Version 4)” on page 599).
Show
◆ VLAN ID – ID of configured VLAN.
◆ VLAN Name – Name of the VLAN.
◆ Status – Operational status of configured VLAN.
◆ Remote VLAN – Shows if RSPAN is enabled on this VLAN (see “Configuring
Remote Port Mirroring” on page 124).
◆ L3 Interface – Shows if the interface supports Layer 3 configuration.
Web Interface
To create VLAN groups:
1. Click VLAN, Static.
2. Select Add from the Action list.
3. Enter a VLAN ID or range of IDs.
4. Mark Enabled to configure the VLAN as operational.
5. Specify whether the VLANs are to be used for remote port mirroring.
6. Click Apply.
To Next Page
Loading...
Need help?
General