Chapter 50
| IP Routing Commands
Routing Information Protocol (RIP)
– 978 –
ip rip receive version This command specifies a RIP version to receive on an interface. Use the no form to
restore the default value.
Syntax
ip rip receive version {1 | 2}
no ip rip receive version
1 - Accepts only RIPv1 packets.
2 - Accepts only RIPv2 packets.
Default Setting
RIPv1 and RIPv2 packets
Command Mode
Interface Configuration (VLAN)
Command Usage
â—† Use this command to override the global setting specified by the RIP version
command.
â—† You can specify the receive version based on these options:
â–
Use version 1 or version 2 if all routers in the local network are based on
RIPv1 or RIPv2, respectively.
â–
Use the default of version 1 or 2 if some routers in the local network are
using RIPv2, but there are still some older routers using RIPv1.
Example
This example sets the interface version for VLAN 1 to receive RIPv1 packets.
Console(config)#interface vlan 1
Console(config-if)#ip rip receive version 1
Console(config-if)#
Related Commands
version (975)
ip rip receive-packet This command configures the interface to receive RIP packets. Use the no form to
disable this feature.
Syntax
[no] ip rip receive-packet
Default Setting
Enabled
To Next Page
Loading...
Need help?
General