Figures
ā 30 ā
Figure 310: Showing Maintenance Associations 503
Figure 311: Configuring Detailed Settings for Maintenance Associations 504
Figure 312: Configuring Maintenance End Points 505
Figure 313: Showing Maintenance End Points 506
Figure 314: Configuring Remote Maintenance End Points 507
Figure 315: Showing Remote Maintenance End Points 508
Figure 316: Transmitting Link Trace Messages 510
Figure 317: Transmitting Loopback Messages 511
Figure 318: Transmitting Delay-Measure Messages 513
Figure 319: Showing Information on Local MEPs 514
Figure 320: Showing Detailed Information on Local MEPs 516
Figure 321: Showing Information on Local MIPs 517
Figure 322: Showing Information on Remote MEPs 518
Figure 323: Showing Detailed Information on Remote MEPs 520
Figure 324: Showing the Link Trace Cache 522
Figure 325: Showing Settings for the Fault Notification Generator 523
Figure 326: Showing Continuity Check Errors 524
Figure 327: Enabling OAM for Local Ports 527
Figure 328: Displaying Statistics for OAM Messages 528
Figure 329: Displaying the OAM Event Log 529
Figure 330: Displaying Status of Remote Interfaces 530
Figure 331: Running a Remote Loop Back Test 532
Figure 332: Displaying the Results of Remote Loop Back Testing 533
Figure 333: Configuring UDLD Protocol Intervals 535
Figure 334: Configuring UDLD Interface Settings 537
Figure 335: Displaying UDLD Neighbor Information 538
Figure 336: Multicast Filtering Concept 540
Figure 337: Configuring General Settings for IGMP Snooping 546
Figure 338: Configuring a Static Interface for a Multicast Router 547
Figure 339: Showing Static Interfaces Attached a Multicast Router 548
Figure 340: Showing Current Interfaces Attached a Multicast Router 548
Figure 341: Assigning an Interface to a Multicast Service 550
Figure 342: Showing Static Interfaces Assigned to a Multicast Service 550
Figure 343: Configuring IGMP Snooping on a VLAN 555
Figure 344: Showing Interface Settings for IGMP Snooping 556
To Next Page
Loading...
