Chapter 13
| Basic Administration Protocols
Link Layer Discovery Protocol
– 400 –
â–
Network Policy – This option advertises network policy configuration
information, aiding in the discovery and diagnosis of VLAN configuration
mismatches on a port. Improper network policy configurations frequently
result in voice quality degradation or complete service disruption.
(Default: Enabled)
◆ MED-Location Civic Address – Configures information for the location of the
attached device included in the MED TLV field of advertised messages,
including the country and the device type.
â–
Country – The two-letter ISO 3166 country code in capital ASCII letters.
(Example: DK, DE or US)
â–
Device entry refers to – The type of device to which the location applies:
â–
Location of DHCP server.
â–
Location of network element closest to client.
â–
Location of client. (This is the default.)
Web Interface
To configure LLDP interface attributes:
1. Click Administration, LLDP.
2. Select Configure Interface from the Step list.
3. Select Configure General from the Action list.
4. Select an interface from the Port or Trunk list.
5. Set the LLDP transmit/receive mode, specify whether or not to send SNMP trap
messages, and select the information to advertise in LLDP messages.
6. Click Apply.
To Next Page
Loading...
Need help?
General