Chapter 13
| Basic Administration Protocols
Connectivity Fault Management
– 509 –
Parameters
These parameters are displayed:
◆ MD Index – Domain index. (Range: 1-65535)
◆ MA Index – MA identifier. (Range: 1-2147483647)
◆ Source MEP ID – The identifier of a source MEP that will send the link trace
message. (Range: 1-8191)
â—† Target
â–
MEP ID – The identifier of a remote MEP that is the target of a link trace
message. (Range: 1-8191)
â–
MAC Address – MAC address of a remote MEP that is the target of a link
trace message. This address can be entered in either of the following
formats: xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx
◆ TTL – The time to live of the link trace message. (Range: 0-255 hops)
Web Interface
To transmit link trace messages:
1. Click Administration, CFM.
2. Select Transmit Link Trace from the Step list.
3. Select an entry from MD Index and MA Index.
4. Specify the source MEP, the target MEP using either its MEP identifier or MAC
address, and set the maximum number of hops allowed in the TTL field.
5. Click Apply.
6. Check the results in the Link Trace cache (see "Displaying the Link Trace
Cache").
To Next Page
Loading...
Need help?
General