Chapter 4
| System Management Commands
System Status
– 129 –
SWCTRL_TD 0.00 0.00 0.00
SWDRV_MONITOR 21.00 19.25 21.00
SYS_MGMT_PROC 0.00 0.00 0.00
SYSDRV 0.00 0.00 0.00
SYSLOG_TD 0.00 0.00 0.00
SYSMGMT_GROUP 0.00 0.00 0.00
SYSTEM 0.00 0.00 0.00
UDLD_GROUP 0.00 0.00 0.00
WTDOG_PROC 0.00 0.00 0.00
XFER_GROUP 0.00 0.00 0.00
XFER_TD 0.00 0.00 0.00
Console#
show running-config This command displays the configuration information currently in use.
Syntax
show running-config [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
vlan vlan-id (Range: 1-4094)
Command Mode
Privileged Exec
Command Usage
◆ Use the interface keyword to display configuration data for the specified
interface.
◆ Use this command in conjunction with the show startup-config command to
compare the information in running memory to the information stored in non-
volatile memory.
◆ This command displays settings for key command modes. Each mode group is
separated by “!” symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
■
MAC address for each switch in the stack
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for VLANs
■
Interface settings
To Next Page
Loading...
Need help?
General