D
CLI OverviewThe config Branch
D-27
Command Line Interface
Parameters This command has five parameters. Up to six community names and
trap recipients may be defined.
Command Example
Root> config snmp addCommunity 1 "CommunityName1" enabled
123.123.123.123. 162
config.snmp.authTraps
Syntax authTraps enabledState
Purpose This command enables or disables the authorization traps to be sent
to SNMP management stations when unauthorized stations try to
access SNMP information from the switch.
commIndex
Specifies the community to be created or edited.
Valid values are integers 1 through 6.
commName
Specifies the community name of the
community specified by commIndex. The
community name must not exceed 32 characters
in length. Valid characters include all those in
the ISO Latin-1 character set. Duplicate
community names are allowed, but the
corresponding writeAuthorization values must
match.
writeAuthoriza
tion
Specifies the write authorization state of the
community. Valid values are enabled and
disabled. Boolean 1 or 0 may be substituted as
values.
trapRecipient
Specifies the trap recipient. Values must be 4
bytes in dotted-decimal format.
udpPortNum
Specifies the UDP port number to which the
switch will send traps for each recipient. The
values must be a decimal number; the default
value is 162. Valid values include all legal UDP
port numbers.
To Next Page
Loading...
Need help?
General
