D
CLI OverviewThe config Branch
D-29
Command Line Interface
Output The switch configuration data is displayed as a table that includes the
following properties
◆ Authorization Traps — The state of the authorization traps (for
example, enabled) that will be sent to SNMP management
stations when unauthorized stations attempt to access SNMP
information from the switch.
◆ Index — The community index number.
◆ Community Name — The name of the community.
◆ WriteAuth — The write authorization state.
◆ Trap Recipient — The address of the trap recipient.
◆ UDP Port — The user datagram protocol (UDP) port number to
which the director will send traps for each recipient.
Output Example The output from config.snmp.show is similar to the following:
config.switch.bbCredit
Syntax bbCredit bbCreditValue
Purpose This command sets the buffer-to-buffer credit value for all ports,
except those ports configured for extended distance.
Description The switch must be off line before issuing this command. Use
maint.system.setOnlineState to set the switch off line.
Parameters This command has one parameter.
Authorization Traps: Enabled
Index
-----
1
2
3
4
5
6
Community Name
------------------
CommunityName1
CommunityName1
CommunityName1
public
WriteAuth
------------
Enabled
Enabled
Disabled
Enabled
Trap Recipient
----------------
123.123.123.123
10.25.25.10
132.44.85.224
UDP Port
---------
162
144
162
162
bbCreditValue
Specifies the new buffer-to-buffer credit value.
This parameter must be an integer in the range
1 through 60.
To Next Page
Loading...
Need help?
General
