EMC Connectrix DS-32M2 - Page 278

D
D-30 Connectrix DS-32M2 User Guide
Command Line Interface
Command Example Root> config switch bbCredit 2
config.switch.edTOV
Syntax edTOV timeoutValue
Purpose This command sets the E_D_TOV for the switch.
Description The switch must be off line before issuing this command. Use
maint.system.setOnlineState to set the switch off line.
Special care should be used when scripting this command due to its
relationship with R_A_TOV.
Parameters This command has one parameter.
Command Example
Root> config switch edTOV 4
config.switch.interopMode
Syntax interopMode interopMode
Purpose This command sets the interoperability mode for the switch.
Description The switch must be off line before issuing this command. Use
maint.system.setOnlineState to set the switch off line.
Parameters This command has one parameter.
Command Example
Root> config switch interopMode open
timeoutValue
Specifies the new E_D_TOV value. The units for
this value are tenths of a second. This parameter
must be an integer in the range 2 through 600
(0.2 second to 60 seconds), and it must be
smaller than the R_A_TOV.
interopMode
Specifies the interoperability mode. Valid
values are mcdata (McDATA Fabric 1.0) and
open (Open Fabric 1.0)