D
perfshow
D-59
Command Line Interface
Output Example The output from show.frus is similar to the following::
show.ip.ethernet
Syntax ethernet
Purpose This command displays Ethernet attributes.
Parameters This command has no parameters.
Command Example
Root> show ip ethernet
Output The ethernet attributes data is displayed as a table that includes the
following properties.
◆ IP Address — The IP address for the Ethernet adapter as set in
the config.lan.ipAddress command.
◆ Gateway Address — The gateway address for the Ethernet
adapter as set in the config.lan.gatewayAddress command.
◆ Subnet Mask — The subnet mask for the Ethernet adapter as set
in the config.lan.subnetMask command.
Output Example The output from show.ip.ethernet is similar to the following:
FRU
--------
CTP
Power
Power
Fan
Fan
Fan
Fan
Position
--------
0
0
1
0
1
2
3
State
------
Active
Active
Active
Active
Active
Active
Active
Serial Num
----------
118031905
N/A
N/A
N/A
N/A
N/A
N/A
Part Num
--------------
S802578490
N/A
N/A
N/A
N/A
N/A
N/A
Beacon
------
off
N/A
N/A
N/A
N/A
N/A
N/A
Pwr On Hrs
----------
799
799
799
799
799
799
799
LAN Information
IP Address: 144.49.10.15
Gateway Address: 144.49.10.1
Subnet Mask: 255.255.255.0
To Next Page
Loading...