FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-6
Troubleshooting the LCD Messages (continued)
ERR LAM HEATER
OFF
See the next column. If this problem persists, call for
technical assistance.
ERR LAM HEATER
TIMEOUT
See the next column. If this problem persists, call for
technical assistance.
ERROR CARD
JAM: LAM
A card is jammed in the
Lamination module area
of the Printer.
Clear the jam according to the
steps in the Troubleshooting
section of the User Guide. Press
QUIT to clear this message.
FIRMWARE
ERROR
An unspecified error was
detected by the Printer
Firmware. The Printer
operation may be
unstable.
Cycle power on the Printer and try
the operation again. If this
problem persists, call for technical
assistance.
FLIPPER
ALIGNMENT
Unable to align flipper. Check for obstruction. If the
problem persists, call for technical
assistance. See Resolving the
Card Jam on the Flipper Table.
HEAD LIFT
ERROR
The Printer was unable to
start lowering the
Printhead.
Press RESUME to retry or
CANCEL to abort. If the problem
persists, call for technical
assistance. See Resolving the
Headlift Error Message.
HEAD LOADING An unrecoverable error
occurred while printing.
Contact technical support if this
error repeats. Press CANCEL to
abort this card.
HEAD
RESISTANCE
LCD setting for head
resistance is out of
range.
Reset the correct value according
to the steps in the
Troubleshooting Section. If this
problem persists, call for technical
assistance.
To Next Page
Loading...
