16 Appendix
610
Appendix
16
Stacker Capacity Output tray : 500 sheets (A4)
Finisher tray (not stapled)
A4: 2,000 sheets
B4 or larger: 1,500 sheets
Mixed stack*
1
: 300 sheets
Finisher tray (stapled)
A4: 200 sets or 2,000 sheets
B4 or larger: 100 sets or 1,500 sheets
Booklet tray : 20 sets*
2
*1
Larger size paper is stacked on top of smaller size paper.
*2
Some papers may not be placed into tray depending on the paper
type.
Important • When using 80 gsm paper
Staple Capacity : 100 sheets (64 - 300 gsm)
Important • When using paper over A4, or 8.5 × 11", maximum stapled
sheets is 65 sheets.
• Depending on the type of paper that is being stapled, the
stapled nails may be bent.
Paper Size : Maximum: A3, 11 × 17",
Minimum: B5
Position : 1 place (front : angled stapling, center :
parallel stapling, back : parallel stapling
*
)
: 2 places (parallel stapling)
* The supported paper is A4 and A3.
Punch Paper Size : A3
*
, 11 × 17"
*
, B4, A4, A4
*
, 8.5 ×
11", 8.5 × 11" , B5 , 7.25 ×
10.5"
*
, 8 × 10"
*
, 8 × 10" , 16K,
Cover A4 , 9 × 11"
*
, 215 × 315 mm,
8.5 × 13", 8.5 × 14", 11 × 15", 8K
* 4 holes (optional) are available.
Number of Holes : 2 or 4, 3 (optional)
Note • US 2/3 Hole Punch Kit for D2 P-Finisher is required for 3
holes.
Paper Weight : 64 - 220 gsm
Booklet Finishing Maximum number of sheets: 20 sheets
*1
,
5 sheets (center folding),
Paper size: Maximum: 13 × 18",
Minimum: A4, 8.5 × 11"
Paper type: 64 - 300 gsm
*2
,
64 - 300 gsm (center folding),
64 - 300 gsm (single folding)
*1 14 sheets when attaching a cover. The maximum number of sheets
for center folding can be changed by customer engineers.
*2
Up to 220 gsm paper can be used for covers. When 91 to 220 gsm
paper is used for a cover, paper that can be used for body contents
becomes 64 to 80 gsm.
Important • When using 80 gsm paper
Folding
(Z-Fold, Three Fold)
<Z-Fold>
Important • D2 Folder Unit (optional) is required.
Paper size : A3, B4, 11 × 17"
Paper type : 64 - 90 gsm
<Three-Fold>
Paper size : A4, 8.5 × 11"
Paper type : 64 - 90 gsm
To Next Page
Loading...
