Copying 168
Paper Supply
To select a tray.
1 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Making Copies From the Document Glass" on page 162
• "Making Copies From the ADF" on page 164
2 Press the Copy button.
3 Select Paper Supply, and then press the button.
4 Select the desired setting, and then press the button.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
NOTE:
• Tray 2 is only available when the optional 250-sheet feeder is installed.
Tray 1: xxx* The paper is fed from Tray 1.
Tray 2: xxx The paper is fed from Tray 2.
Manual Feed Slot: xxx The paper is fed from the single sheet feeder (SSF).
To Next Page
Loading...
