Using the Operator Panel Menus and Keypad 326
• Power Saver Wake Up
Purpose:
To specify whether to wake up from the Low Power or Sleep mode when OnHook is set to Off.
Values:
• Auto Reset
Purpose:
To automatically reset the settings for Copy, Scan, or Fax to the default settings and return to the
standby mode after you do not specify any settings for the specified time.
Values:
• Fault Time-out
Purpose:
To specify the amount of time the printer waits before canceling a job that stops abnormally. The print
job is cancelled if the time-out time is exceeded.
Values:
• Job Time-out
Purpose:
To specify the amount of time the printer waits for data to arrive from the computer. The print job is
cancelled if the time-out time is exceeded.
Values:
OffHook Wake Up Off
*
Does not wake up from the Low Power or Sleep mode when OnHook
is set to Off.
On Wakes up from the Low Power or Sleep mode when OnHook is set to
Off.
45sec
*
1min
2min
3min
4min
Off Disables the fault time-out.
On
*
60sec
*
Sets the amount of time the printer waits before canceling a job that
stops abnormally.
3–300 sec.
Off Disables the job time-out.
On
*
30sec
*
Sets the time the printer waits for data to arrive from the computer.
5–300 sec.
To Next Page
Loading...
Need help?
General
