Troubleshooting 394
îš„ Jam Problems
This section includes:
• "Standard 250-Sheet Tray Misfeed Jam" on page 394
• "SSF Misfeed Jam" on page 395
• "Optional 250-Sheet Feeder Misfeed Jam" on page 396
• "Regi Jam (Exit Sensor On JAM)" on page 396
• "Exit Jam (Exit Sensor Off JAM)" on page 397
• "Standard 250-Sheet Tray/Optional 250-Sheet Feeder Multi-feed Jam" on page 397
• "SSF Multi-feed Jam" on page 397
Standard 250-Sheet Tray Misfeed Jam
Problem Action
Print media misfeeds occur in the
standard 250-sheet tray.
Ensure that the standard 250-sheet tray is properly inserted.
If the problem persists, verify that the correct print media is being
used.
Verify that the correct print media is being used.
See also:
• "Usable Print Media" on page 116
If not, use the print media recommended for the printer.
If the problem persists, ensure that the print media is not damp.
Ensure that the print media is not curled.
If the problem persists, fan the print media.
Ensure that the print media is not damp.
If the print media is damp, turn over the print media.
If the problem persists, use print media that is not damp.
If the print media is not damp, fan the print media.
Fan the print media.
If the problem persists, wipe the feed roller in the standard 250-sheet
tray with a cloth moistened with water.
Wipe the feed roller in the standard 250-sheet tray with a cloth
moistened with water.
If the problem persists, replace the drum cartridge if you have a spare
cartridge.
Replace the drum cartridge if you have a spare cartridge.
If the problem persists, contact the Fuji Xerox local representative
office or an authorised dealer.
To Next Page
Loading...
Need help?
General
