Copying 178
Sharpness
To adjust the sharpness to make the copy image sharper or softer than the original.
1 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Making Copies From the Document Glass" on page 162
• "Making Copies From the ADF" on page 164
2 Press the Copy button.
3 Select Sharpness, and then press the button.
4 Select the desired setting, and then press the button.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
5 Press the Start button to begin copying.
Sharper Makes the copy image sharper than the original.
Normal* The color clarity of the image is the same as the original.
Softer Makes the copy image softer than the original.
To Next Page
Loading...
