Fuji Xerox DocuPrint CM305 df - Color Balance

Using the Operator Panel Menus and Keypad 346
• Color Balance
Purpose:
To specify the default color balance level within the range of -3 to +3.
Values:
•2-Sided
Purpose:
To print on both sides of a sheet of paper.
Values:
Yellow Low Dens. 0
*
Sets the color balance level of low density yellow.
-3 to +3
Yellow Med.
Dens.
0
*
Sets the color balance level of medium density yellow.
-3 to +3
Yellow High Dens. 0
*
Sets the color balance level of high density yellow.
-3 to +3
Magen. Low
Dens.
0
*
Sets the color balance level of low density magenta.
-3 to +3
Magen. Med.
Dens.
0
*
Sets the color balance level of medium density magenta.
-3 to +3
Magen. High
Dens.
0
*
Sets the color balance level of high density magenta.
-3 to +3
Cyan Low Dens. 0
*
Sets the color balance level of low density cyan.
-3 to +3
Cyan Med. Dens. 0
*
Sets the color balance level of medium density cyan.
-3 to +3
Cyan High Dens. 0
*
Sets the color balance level of high density cyan.
-3 to +3
Black Low Dens. 0
*
Sets the color balance level of low density black.
-3 to +3
Black Med. Dens. 0
*
Sets the color balance level of medium density black.
-3 to +3
Black High Dens. 0
*
Sets the color balance level of high density black.
-3 to +3
1→1-Sided* Prints on one side of a sheet of paper.
Long Edge Binding Prints on both sides of a sheet of paper to be bound by long edge.
Short Edge Binding Prints on both sides of a sheet of paper to be bound by short edge.