Fuji Xerox DocuPrint CM305 df - Scan Defaults

347 Using the Operator Panel Menus and Keypad
•N-Up
Purpose:
To print two original pages to fit onto one sheet of paper.
Values:
• Margin Top/Bottom
Purpose:
To specify the value of the top and bottom margins.
Values:
• Margin Left/Right
Purpose:
To specify the value of the left and right margins.
Values:
• Margin Middle
Purpose:
To specify the value of the middle margin.
Values:
Scan Defaults
To modify the defaults for the Scan menu.
Scan Defaults allows you to configure the following items in addition to the items under the Scan
menu.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
Off* Does not perform N-up printing.
Auto Automatically reduces the original pages to fit onto one sheet of
paper.
ID Card Copy Prints the original pages onto one sheet of paper in the original size.
Manual Prints the original pages onto the one sheet of paper in the size
specified in Reduce/Enlarge.
4 mm*/0.2 inch* Specify the value in increments of 1 mm/0.1 inch.
0-50 mm/0.0-2.0 inch
4 mm*/0.2 inch* Specify the value in increments of 1 mm/0.1 inch.
0-50 mm/0.0-2.0 inch
0 mm*/0.0 inch* Specify the value in increments of 1 mm/0.1 inch.
0-50 mm/0.0-2.0 inch