Faxing 256
îš„ Sending a Fax Manually
1 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Loading an Original Document on the ADF" on page 249
• "Loading an Original Document on the Document Glass" on page 250
2 Press the Fax button.
3 Adjust the document resolution to suit your fax needs.
See also:
• "Resolution" on page 252
• "Lighten/Darken" on page 253
4 Select OnHook, and then press the button.
5 Select On, and then press the button.
6 Enter the remote fax machine's fax number using the numeric keypad.
NOTE:
• You can enter a fax number using the ten key, *, and #.
• Pressing the Redial/Pause button enables you to enter a pause in the fax number.
• Entering "=" in the fax number enables dial tone detection.
• Entering ":" enables you to switch dialing type from dial pulse (DP) to push button (PB).
7 If the document is loaded in the ADF, press the Start button.
If the document is not loaded in the ADF, press the Start button, press the or button until
the desired setting appears, and then press the button.
NOTE:
• By pressing the
Stop button, you can cancel the fax job at any time while sending the fax.
To Next Page
Loading...
Need help?
General
