325 Using the Operator Panel Menus and Keypad
•Port Status
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned
off and then on again.
Values:
• Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
System Settings
Use System Settings to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Power Saver Timer
Purpose:
To specify the time for transition to power saver mode.
Values:
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less
energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer
ready to operate with minimum warm-up time. Select a value between 5 and 30 minutes for power
saver mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives
data from the computer or remote fax machine. You can also change the status of the printer to the
standby mode by pressing the Energy Saver button on the operator panel.
Disable Disables the USB interface.
Enable
*
Enables the USB interface.
Auto Sets the PostScript communications protocol automatically.
Standard Sets the PostScript communications protocol to Standard.
BCP Sets the PostScript communications protocol to BCP.
TBCP* Sets the PostScript communications protocol to TBCP.
Binary Sets the PostScript communications protocol to Binary.
Low Power
Timer
3min
*
Specifies the time taken by the printer to enter Low Power mode after
it finishes a job.
3–60 min.
Sleep Timer 6min
*
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
1–6 min.
To Next Page
Loading...
Need help?
General
