Fuji Xerox DocuPrint CM305 df User Manual

317 Using the Operator Panel Menus and Keypad
• Initialize NVM
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and
rebooting the printer, all wired network settings are reset to their default values.
Values:
• Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Ans Select
Purpose:
To select the default fax receiving mode.
Values:
Yes Initializes the wired network data stored in NVM.
No
*
Does not initialize the wired network data stored in NVM.
Auto* Sets the PostScript communications protocol automatically.
Standard Sets the PostScript communications protocol to Standard.
BCP Sets the PostScript communications protocol to BCP.
TBCP Sets the PostScript communications protocol to TBCP.
Binary Sets the PostScript communications protocol to Binary.
TEL Mode Automatic fax reception is turned off. You can receive a fax by picking
up the handset of the external phone and then pressing the remote
receive code, or by setting OnHook to On (you can hear voice or fax
tones from the remote machine) and then pressing
Start button.
FAX Mode* Automatically receives faxes.
TEL/FAX Mode When the printer receives an incoming fax, the external telephone
rings for the time specified in Auto Ans. Tel/Fax, and then the
printer automatically receives a fax. If an incoming call is not a fax,
the printer beeps from the internal speaker indicating that the call is a
telephone call.

Fuji Xerox DocuPrint CM305 df Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM305 df
Category	Printer
Language	English