Copying 186
Margin Top/Bottom
To specify the top and bottom margins of the copy.
1 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Making Copies From the Document Glass" on page 162
• "Making Copies From the ADF" on page 164
2 Press the Copy button.
3 Select Margin Top/Bottom, and then press the button.
4 Press the or button or use the numeric keypad to set the desired value, and then press the
button.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
5 Press the Start button to begin copying.
0.2 inch* (4 mm*) Specify the value in increments of 0.1 inch (1 mm).
0.0–2.0 inch (0–50 mm)
To Next Page
Loading...
