335 Using the Operator Panel Menus and Keypad
•Adjust ColorRegi
Purpose:
To manually perform color registration adjustment.
Manual Color Registration Adjustments are required when the printer is initially installed and after the
printer is moved.
NOTE:
• The Adjust ColorRegi feature can be configured when Auto Regi Adjust is set to Off.
Values:
NOTE:
• Ensure that you remove the paper from the single sheet feeder (SSF) before performing Auto Adjust.
• Clean Developer
Purpose:
To stir the toner in a new toner cartridge.
Values:
• Toner Refresh
Purpose:
To clean the toner in each toner cartridge.
Values:
Auto Adjust Automatically performs color registration correction.
Color Regi Chart Prints a color registration chart. The color registration chart prints a
lattice pattern of yellow, magenta, and cyan lines. On the chart, find
the values on the right side that are next to the line that is perfectly
straight for each of the three colors. If the value for this line is 0,
color registration adjustment is not required. If the value for this
line is any value other than 0, specify the adjustment values for
lateral adjustment and process adjustment under Enter Number.
Enter Number LY -9 to +9 Sets lateral (perpendicular to paper feed direction) and process
(paper feed direction) color adjustment values individually for
Yellow, Magenta, and Cyan. Enter a number in order of lateral
adjustment (left), lateral adjustment (right), and process
adjustment. Press the
button to save all the settings.
LM
LC
RY -9 to +9
RM
RC
PY -9 to +9
PM
PC
Yes Stirs the toner in a new toner cartridge.
No
*
Does not stir the toner in a new toner cartridge.
Yellow Yes Cleans the toner in the yellow toner cartridge.
No* Does not clean the toner in the yellow toner cartridge.
To Next Page
Loading...
Need help?
General
