259 Faxing
Sending a Delayed Fax
The Delayed Start mode can be used to save scanned documents for transmission at a specified time
to take advantage of lower long distance rates.
1 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Loading an Original Document on the ADF" on page 249
• "Loading an Original Document on the Document Glass" on page 250
2 Press the Fax button.
3 Adjust the document resolution to suit your fax needs.
See also:
• "Resolution" on page 252
• "Lighten/Darken" on page 253
4 Select Delayed Start, and then press the button.
5 Select On, and then press the button.
6 Enter the start time using the numeric keypad or select the start time using the or button,
and then press the button.
7 Select Fax to, and then press the button.
8 Select Keypad, and then press the button.
9 Enter the number of the remote machine using the numeric keypad, and then press the
button.
You can also use speed or group dial numbers.
See also:
• "Automatic Dialing" on page 276
10 Press the Start button to scan data.
Once Delayed Start mode is activated, your printer stores all of the documents to be faxed into its
memory and sends them at the specified time. After faxing in the Delayed Start mode is complete, the
data in the memory is cleared.
NOTE:
• If you turn off and on the printer, the stored documents are sent as soon as the printer is activated.
To Next Page
Loading...
Need help?
General
