Fuji Xerox DocuPrint CM305 df User Manual

181 Copying
 Color Balance
To specify the default color balance level within the range of -3 to +3.
1 Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Making Copies From the Document Glass" on page 162
• "Making Copies From the ADF" on page 164
2 Press the System button.
3 Select Defaults Settings, and then press the button.
4 Select Copy Defaults, and then press the button.
5 Select Color Balance, and then press the button.
6 Select the desired setting, and then press the button.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
Yellow Low Dens. 0
*
Sets the color balance level of low density yellow.
-3 to +3
Yellow Med. Dens. 0
*
Sets the color balance level of medium density yellow.
-3 to +3
Yellow High Dens. 0
*
Sets the color balance level of high density yellow.
-3 to +3
Magen. Low Dens. 0
*
Sets the color balance level of low density magenta.
-3 to +3
Magen. Med. Dens. 0
*
Sets the color balance level of medium density magenta.
-3 to +3
Magen. High Dens. 0
*
Sets the color balance level of high density magenta.
-3 to +3
Cyan Low Dens. 0
*
Sets the color balance level of low density cyan.
-3 to +3
Cyan Med. Dens. 0
*
Sets the color balance level of medium density cyan.
-3 to +3
Cyan High Dens. 0
*
Sets the color balance level of high density cyan.
-3 to +3
Black Low Dens. 0
*
Sets the color balance level of low density black.
-3 to +3
Black Med. Dens. 0
*
Sets the color balance level of medium density black.
-3 to +3

Fuji Xerox DocuPrint CM305 df Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM305 df
Category	Printer
Language	English