Troubleshooting 396
Optional 250-Sheet Feeder Misfeed Jam
Regi Jam (Exit Sensor On JAM)
Problem Action
Print media misfeeds occur in the
optional 250-sheet feeder.
Ensure that the optional 250-sheet feeder is properly inserted.
If the problem persists, ensure that the side cover is closed.
Ensure that the side cover is closed.
If the problem persists, verify that the correct print media is being
used.
Verify that the correct print media is being used.
See also:
• "Usable Print Media" on page 116
If not, use the print media recommended for the printer.
If the problem persists, ensure that the print media is not damp.
Ensure that the print media is not curled.
If the problem persists, fan the print media.
Ensure that the print media is not damp.
If the print media is damp, turn over the print media.
If the problem persists, use print media that is not damp.
If the print media is not damp, fan the print media.
Fan the print media.
If the problem persists, wipe the feed roller in the optional 250-sheet
feeder with a cloth moistened with water.
Wipe the feed roller in the optional 250-sheet feeder with a cloth
moistened with water.
If the problem persists, contact the Fuji Xerox local representative
office or an authorised dealer.
Problem Action
Regi jam (Exit Sensor On JAM)
occurs.
Ensure that the drum cartridge is installed correctly.
If the problem persists, replace the drum cartridge if you have a spare
cartridge as instructed in "Replacing the Drum Cartridge" on
page 474.
Replace the drum cartridge if you have a spare cartridge as instructed
in "Replacing the Drum Cartridge" on page 474.
If the problem persists, contact the Fuji Xerox local representative
office or an authorised dealer.
To Next Page
Loading...
Need help?
General
