401 Troubleshooting
The envelope is creased after
printed.
Make sure that the envelope is loaded in the standard 250-sheet tray
or SSF as instructed in "Loading Envelope in the Standard 250-Sheet
Tray" on page 123 or "Loading Envelope in the Single Sheet Feeder
(SSF)" on page 126.
Page breaks in unexpected
places.
Increase the value for the time-out on the operator panel or
CentreWare Internet Services.
Print media does not stack neatly
in the output bin.
Turn the print media stack over in the tray.
Cannot print from the standard
250-sheet tray because the print
media in the tray is curled.
Load the print media into the SSF.
Problem Action
To Next Page
Loading...
Need help?
General
