GS corpuls3 - Page 258

Procedure in case of malfunctions User Manual corpuls
3
246 ENG - Version 2.1 – P/N 04130.2
Alarm message Priority Explanation/Measure
Phonebook upload
failed
Low priority  The phonebook source cannot be read.
 If the phone book source is the SIM card, check the
SIM card.
 If the phonebook source is the corpuls
3
, contact
your authorised sales and service partners.
PP < [NUMBER]/min
PP > [NUMBER]/min
High priority  The measured pulse rate exceeds/falls below the
upper/lower alarm limit.
 Check the patient's vital signs.
Printer paper jammed
Medium priority  The paper has become jammed during the printing
process.
 Open the paper flap and remove the paper jam. To
do this, pull the paper slowly and carefully forwards,
close the paper flap and tear the paper off on the
cutting edge.
 The printer speed is configured to 6.25 mm/sec and
the marking indicating the end of the paper roll is
visible.
Printer temp. too high
Printer temp. high (P-
box)
Medium priority  The printing head is currently too hot and printing is
not possible.
 Leave monitoring unit to cool down, if possible.
Printer voltage too low
Printer voltage low (P-
box)
Medium priority  Alarm message shown on the display of the
monitoring unit and patient box.
 The battery charge of the monitoring unit is too low
or the battery is missing, so that printing is currently
not possible.
 Charge monitoring unit or insert into a charging
bracket.
Printout aborted
Medium priority  The connection between monitoring unit and patient
box was interrupted during the printing process.
 Reduce the distance between the modules or
 Connect the modules mechanically.
Radio conn. not
available
Radio conn. not
available (P-box)
Low priority  A radio module is faulty.
 The corpuls
3
can only be used as a compact
device with an ad-hoc connection.
 Contact authorised sales and service partners.
Refill printer paper
Medium priority  The roll of paper in the printer is used up and the
marking is visible. Insert a new roll.
Replace battery (Defib)
Replace battery
(Monitor)
Replace battery (P-
Box)
High priority  The battery has to be checked immediately and
replaced, if necessary.
 The corpuls
3
is possibly not functioning correctly
and must not be used.
 Contact authorised sales and service partners.