SECONDARY SYSTEM FUNCTION SETTINGS
199
6. If Manual was selected, set F1
(IP Addr), F2 (NetMask) and
F3 (Gateway) in turn.
7. The IP address, net mask or gateway settings
become highlighted in the parameter window.
8. Use the number pad to enter
the IP address, Net mask or
gateway. Use the decimal
point as a field separator.
9. Press F5 (Done) to confirm
the settings.
10. Finally, press F5 (Done) to
confirm all the IP
configuration settings.
LAN Host Name
The following describes how to set the host name
for the unit when used in the LAN interface.
To Next Page
Loading...
Need help?
General
