GW Instek MFG-2000 Series - Safety Guidelines

SAFETY INSTRUCTIONS
7
Double Insulated
Do not dispose electronic equipment as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased.
Safety Guidelines
General
Guideline
CAUTION
 Do not place heavy objects on the instrument.
 Do not place flammable objects on the
instrument.
 Avoid severe impact or rough handling that
may damage the function generator.
 Avoid discharges of static electricity on or near
the function generator.
 Use only mating connectors, not bare wires, for
the terminals.
 The instrument should only be disassembled by
a qualified technician.
(Measurement categories) EN 61010-1:2010 (Third Edition)specifies
the measurement categories and their requirements as follows. The
MFG-2000 falls under category II.
 Measurement category IV is for measurement performed at the
source of a low-voltage installation.
 Measurement category III is for measurement performed in a
building installation.
 Measurement category II is for measurement performed on
circuits directly connected to a low voltage installation.
 Measurement category I is for measurements performed on
circuits not directly connected to Mains.