MFG-2000 Series User Manual
268
Returns the year (2010) and version for that year
(1).
This command sets the Operation Complete Bit
(bit 0) of the Standard Event Status Register after
the function generator has completed all pending
operations. For the MFG-2000, the *OPC command
is used to indicate when a sweep or burst has
completed.
Before the OPC bit is set, other commands may be
executed.
Returns the OPC bit to the output buffer when all
pending operations have completed. I.e. when the
OPC bit is set.
Commands cannot be executed until the *OPC?
query has completed.
Returns a “1” when all pending operations are
complete.
This command waits until all pending operations
have completed before executing additional
commands. I.e., when the OPC bit is set.
To Next Page
Loading...
