GW Instek MFG-2000 Series - Source[1|2]:Marker:frequency

REMOTE INTERFACE
335
Example
OUTP1:TRIG ON
Enables the Trig out signal.
Query Syntax
OUTPut[1|2]:TRIGger?
Return Parameter
0
Disabled
1
Enable
Example
OUTP1:TRIG?
1
The Trig out signal is enabled.
SOURce[1|2]:MARKer:FREQuency
Source Specific
Command
Description
Sets or queries the marker frequency. The default
marker frequency is 500 Hz. The marker frequency
is used to output a trigger out signal from the
trigger terminal on the rear panel.
Note
The marker frequency must be between the start
and stop frequencies. If the marker frequency is set
to a value that is out of the range, the marker
frequency will be set to the center frequency and a
“settings conflict” error will be generated.
Syntax
SOURce[1|2]:MARKer:FREQuency
{<frequency>|MINimum|MAXimum}
Parameter
<frequency>
1μHz ~ 25 MHz
1μHz ~ 1 MHz (Ramp)
Example
SOUR1:MARK:FREQ +1.0000E+03
Sets the marker frequency to 1 kHz.
Query Syntax
SOURce[1|2]:MARKer:FREQuency? [MINimum|
MAXimum]
Return Parameter
<NR3>
Returns the marker
frequency in Hz.
Example
SOUR1:MARK:FREQ?
+1.0000000000000E+03
Returns the marker frequency (1 kHz).