GW Instek MFG-2000 Series - Source[1|2|3]:Burst:trigger:delay; Source[1|2|3]:Burst:trigger:slope

MFG-2000 Series User Manual
344
Example
SOUR1:BURS:TRIG:SOUR?
IMM
The burst trigger source is set to immediate.
SOURce[1|2|3]:BURSt:TRIGger:DELay
Source Specific
Command
Description
The DELay command is used to insert a delay (in
seconds) before a burst is output. The delay starts
after a trigger is received. The default delay is 0
seconds.
Syntax
SOURce[1|2|3]: BURSt:TRIGger:DELay
{<seconds>|MINimum|MAXimum}
Parameter
<seconds>
0~85 seconds
Example
SOUR1:BURS:TRIG:DEL +1.000E+01
Sets the trigger delay to 1 second.
Query Syntax
SOURce[1|2|3]:BURSt:TRIGger:DELay?
[MINimum|MAXimum]
Return Parameter
<NRf>
Delay in seconds
Example
SOUR1:BURS:TRIG:DEL ?
+1.000E+01
The trigger delay is 1 second.
SOURce[1|2|3]:BURSt:TRIGger:SLOPe
Source Specific
Command
Description
Sets or queries the trigger edge for externally
triggered bursts from the Trigger INPUT terminal
on the rear panel. By default the trigger is rising
edge (Positive).
Syntax
SOURce[1|2|3|3RF]:BURSt:TRIGger:SLOPe
{POSitive|NEGative}
Parameter
POSitive
rising edge
NEGative
falling edge