GW Instek MFG-2000 Series - Source[1|2]:Marker

MFG-2000 Series User Manual
336
SOURce[1|2]:MARKer
Source Specific
Command
Description
Turns the marker frequency on or off. The default
is off.
Note
MARKer ON
The SYNC signal goes logically
high at the start of each sweep and
goes low at the marker frequency.
MARKer OFF
The SYNC terminal outputs a
square wave with a 50% duty
cycle at the start of each sweep.
Syntax
SOURce[1|2]:MARKer {OFF|ON}
Example
SOUR1:MARK ON
Enables the marker frequency.
Query Syntax
SOURce[1|2]:MARKer?
Return Parameter
0
Disabled
1
Enabled
Example
SOUR1:MARK?
1
The marker frequency is enabled.