GW Instek MFG-2000 Series - Source[1|2|3|3 Rf|Pulse]:Voltage:unit

REMOTE INTERFACE
289
Query Syntax
OUTPut[1|2|3|3RF|PULSe]:LOAD?
Return Parameter
DEF
Default
INF
INFinity
Example
OUTP1:LOAD?
DEF
The output is set to the default of 50Ω.
SOURCE[1|2|3|3RF|pulse]:VOLTage:UNIT
Source Specific
Command
Description
Sets or queries the output amplitude units. There
are three types of units: VPP, VRMS and DBM.
Note
The units set with the VOLTage:UNIT command
will be used as the default unit for all amplitude
units unless a different unit is specifically used for
a command.
If the output termination is set to high impedance,
dBm units cannot be used. The Units will
automatically default to Vpp.
Syntax
SOURCEPULSE:VOLTage:UNIT {VPP|VRMS|DBM}
Example
SOURCEPULSE:VOLT:UNIT VPP
Sets the amplitude units to Vpp.
Query Syntax
SOURCEPULSE:VOLTage:UNIT?
Return Parameter
VPP
Vpp
VRMS
Vrms
DBM
dBm
Example
SOURCEPULSE:VOLT:UNIT?
VPP
The amplitude units are set to Vpp.