GW Instek MFG-2000 Series - Error Messages; Command Error Codes

REMOTE INTERFACE
363
Error Messages
The MFG-2000 has a number of specific error codes. Use the
SYSTem:ERRor command to recall the error codes. For more
information regarding the error queue.
Command Error Codes
-101 Invalid character
An invalid character was used in the command
string. Example: #, $, %.
SOURce1:AM:DEPTh MIN%
-102 Syntax error
Invalid syntax was used in the command string.
Example: An unexpected character may have been
encountered, like an unexpected space.
SOURce1:APPL:SQUare , 1
-103 Invalid separator
An invalid separator was used in the command
string. Example: a space, comma or colon was
incorrectly used.
APPL:SIN 1 1000 OR SOURce1:APPL:SQUare
-108 Parameter not allowed
The command received more parameters than were
expected. Example: An extra (not needed) parameter
was added to a command
SOURce1:APPL? 10
-109 Missing parameter
The command received less parameters than
expected. Example: A required parameter was
omitted.
SOURce1:APPL:SQUare .