GW Instek MFG-2000 Series - Save and Recall Commands; Sav; Rcl; Memory:state:delete

REMOTE INTERFACE
361
Save and Recall Commands
Up to 10 different instrument states can be stored to non-volatile
memory (memory locations 0~9).
*SAV
Instrument
Command
Description
Saves the current instrument state to a specified
save slot. When a state is saved, all the current
instrument settings, functions and waveforms are
also saved.
Note
The *SAV command doesn’t save waveforms in
non-volatile memory, only the instrument state.
The *RST command will not delete saved
instrument states from memory.
Syntax
*SAV {0|1|2|3|4|5|6|7|8|9}
Example
*SAV 0
Save the instrument state to memory location 0.
*RCL
Instrument
Command
Description
Recall previously saved instrument states from
memory locations 0~9.
Syntax
*RCL {0|1|2|3|4|5|6|7|8|9}
Example
*RCL 0
Recall instrument state from memory location 0.
MEMory:STATe:DELete
Instrument
Command
Description
Delete memory from a specified memory location.
Syntax
MEMory:STATe:DELete {0|1|2|3|4|5|6|7|8|9}
Example
MEM:STAT:DEL 0
Delete instrument state from memory location 0.