GW Instek MFG-2000 Series - Source[1|2|3|3 Rf]:Frequency:start; Source[1|2|3|3 Rf]:Frequency:stop

REMOTE INTERFACE
329
Example
SOUR1:SWE:STAT?
1
Sweep mode is currently enabled.
SOURce[1|2|3|3RF]:FREQuency:STARt
Source Specific
Command
Description
Sets the start frequency of the sweep. 100Hz is the
default start frequency.
Note
To sweep up or down, set the stop frequency
higher or lower than the start frequency.
Syntax
SOURce[1|2|3|3RF]:FREQuency:STARt
{<frequency>|MINimum|MAXimum}
Parameter
<frequency>
1uHz to Max Frequency
Example
SOUR1:FREQ:STAR +2.0000E+03
Sets the start frequency to 2kHz.
Query Syntax
SOURce[1|2|3|3RF]:FREQuency:STARt? [MINimum|
MAXimum]
Return Parameter
<NR3>
Returns the start frequency
in Hz.
Example
SOUR1:FREQ:STAR?
+2.0000000000000E+03
Returns the maximum start frequency allowed.
SOURce[1|2|3|3RF]:FREQuency:STOP
Source Specific
Command
Description
Sets the stop frequency of the sweep. 1 kHz is the
default start frequency.
Note
To sweep up or down, set the stop frequency
higher or lower than the start frequency.
Syntax
SOURce[1|2|3|3RF]:FREQuency:STOP
{<frequency>|MINimum|MAXimum}
Parameter
<frequency>
1uHz to Max Frequency