MFG-2000 Series User Manual
358
COUPLE
The Couple commands can be used to remotely set the frequency
coupling and amplitude coupling.
SOURce[1|2]:FREQuency:COUPle:MODE
Set the frequency coupling mode.
SOURce[1|2]:FREQuency:COUPle:MODE
{Off|Offset|Ratio}
Disables frequency coupling.
Set frequency coupling to offset mode.
Sets frequency coupling to ratio mode.
SOURce1:FREQuency:COUPle:MODE Offset
Sets the frequency coupling mode to offset.
SOURce[1|2]:FREQuency:COUPle:MODE?
SOURce1:FREQuency:COUPle:MODE?
Frequency coupling is turned off.
SOURce[1|2]:FREQuency:COUPle:OFFSet
Sets the offset frequency when the frequency
coupling mode is set to offset.
SOURce[1|2]:FREQuency:COUPle:OFFSet {frequency}
SOURce1:FREQuency:COUPle:OFFSet 2khz
Sets the offset frequency to 2kHz (the frequency of
CH2 minus CH1 is 2kHz).
SOURce[1|2]:FREQuency:COUPle:OFFSet?
SOURce1:FREQuency:COUPle:OFFSet?