GW Instek MFG-2000 Series - Page 74

MFG-2000 Series User Manual
74
OPERATION
The Operation chapter shows how to output basic
waveform functions. For details on modulation,
sweep, burst and arbitrary waveforms, please see
the Modulation and Arbitrary waveform chapters
on pages 117 and 218.
CH1/CH2 Channel ............................................................ 76
Select Channel .......................................................................................... 76
Setup a Waveform .................................................................................... 76
Sine Waveform ............................................................................... 76
Square Waveform ........................................................................... 77
Triangle Waveform ........................................................................ 79
Pulse Waveform ............................................................................. 79
Ramp Waveform ............................................................................ 81
Noise Waveform ............................................................................ 82
Setting the Load ....................................................................................... 83
Setting the Frequency .............................................................................. 85
Setting the Amplitude .............................................................................. 86
Setting the DC Offset ............................................................................... 87
Setting the Phase ..................................................................................... 88
RF Channel ....................................................................... 90
Setup RF waveform .................................................................................. 90
Sine Waveform ........................................................................................ 91
Square Waveform ..................................................................................... 92
Pulse Waveform ....................................................................................... 93
Ramp Waveform ...................................................................................... 95
Noise Waveform ...................................................................................... 97
Setting the Load ....................................................................................... 97
Setting the Frequency .............................................................................. 98
Setting the Amplitude .............................................................................. 99
Setting the DC Offset ............................................................................. 100
Pulse Channel ................................................................ 102
Setup Pulse waveform ............................................................................ 102
Setting the Pulse Duty Time .................................................................. 103
Setting the Pulse Width.......................................................................... 104
Setting the Pulse Leading Edge Time .................................................... 106