6
Introduction
INTRODUCTION
u Basic Hook-Up
All connections are found on the Accessory Panel on the back of the SKX PRO.
t AC Power
Your Hammond SKX PRO is shipped from the factory set for 120V.AC power. To connect the SKX PRO
to AC power:
1. Locate the AC Power Cord that came with your SKX PRO.
2. Plug the female end of the AC Power Cord into the receptacle on the SKX PRO marked, “AC
IN.”
3. Plug the 3-pronged Power Cord into a grounded AC power outlet.
t Audio Connections
You can either:
1. Connect the SKX PRO to an external sound source (amplifier, studio mixer, or sound
reinforcement direct box),or
2. Connect the SKX PRO to a Leslie Speaker cabinet.
Connecting to an external sound source
1. Use two audio cables with
1
/
4
" plugs on both ends of each cable.
2. Connect one end of each of the audio cables to the audio output connectors (marked LINE
OUT) on the Accessory Panel.
3. Connect the other ends of each cable to the female
1
/
4
" audio input connectors of your sound
source.
If your amplifier has only a single (1) female
1
/
4
" phono plug audio input, you can connect one
end of one cable to the L/MONO audio output connector on the SKX PRO, and the other end
to the female
1
/
4
" audio input connector of your amplifier.
Connecting a Leslie Speaker
The 11-pin Leslie socket on your SKX PRO allows you to connect directly into any Leslie speaker having
an 11-pin interface. If you wish to use a Leslie Speaker with your SKX PRO, the Leslie Speaker should be
connected before turning the power "ON." To do this:
1. Locate an 11-pin Leslie Connector Cable.
2. Plug one end of the Connector Cable into the 11-pin receptacle on the Leslie Speaker.
3. Plug the other end of the Connector Cable into the 11-pin Leslie socket found on the
Accessory Panel of the SKX PRO.
Both the Leslie connections are "keyed,” that is, each connection contains a notch which insures that
the pins properly match up.
HA<O> SKX PRO Reference Guide
To Next Page
