66
Combinations
From the screen at the bottom of the previous page, press the DIRECTION “q” button once.
The box to the right of “LEVEL” should be highlighted.
LEVEL
This Parameter allows you to select the amount of the Reverb (= send level) for each Section. You can
select from 0 (no Reverb) to 127 (maximum Reverb).
Use the DIRECTION “t” and “u” buttons to highlight the Voice Section you want to modify.
Turn the VALUE knob to the right to increase the Reverb Level for the highlighted Voice Section.
Turn the VALUE knob to the left to decrease the Reverb Level for the highlighted Voice Section.
NOTE: The DEPTH Parameter described on the previous page controls the entire REVERB section. This
Parameter allows you to raise or lower the amount or “send level” of REVERB for each Voice Section
independently.
HA<O> SKX PRO Reference Guide
To Next Page
