427
CUSTOM SETS - Pedal Registration
u CUSTOM EDIT -PEDAL REG. FUNCTION Mode
This FUNCTION Mode allows you to select or edit the registrations for the Pedal or Sub-Drawbars.
t WHAT ARE “SUB-DRAWBARS?”
On a tone-wheel Hammond Organ, the harmonic resources for Pedal tones are combined into two
Drawbars each of which draws a combination of harmonics instead of individual harmonics as with the
other Drawbars. Over the years, several different schemes were used to voice the Pedal Drawbars. These
are shown below.
The Custom Pedal Registrations cannot be Recorded as individual Patch Parameters; however, a Custom
Pedal Registration can be Recorded as part of an ORGAN Patch.
The SKX PRO has 3 different Factory Custom Pedal Registrations, indicated by an F which are permanently
written in memory. You can create and Record up to 3 User Custom Pipes which will be indicated by a U.
To create and Record a Custom Pedal Registration, use the CUSTOM PEDAL REG. FUNCTION Mode Page
to edit the Parameters of one of the F Custom Pedal Registrations. After you have made all of your
changes, you can Save them as a U Custom Pedal Registration.
NOTE: For a list of the Factory Custom Pedal Registrations, please consult page 719 of the APPENDIX chapter
of this Guide.
NOTE: For a complete list of the Parameters that can be modified for a Custom Pedal Registration, please
consult page 720 of the APPENDIX chapter of this Guide.
HA<O> SKX PRO Reference Guide
To Next Page
