Hioki IM3536 - Changing the Display Timing Setting (When You Wish to Shorten the Screen Update Interval)

95
Changing the Display Timing Setting (When You Wish to Shorten the Screen Update Interval)
4.4 Changing the Display Timing Setting (When You
Wish to Shorten the Screen Update Interval)
You can set the display timing during continuous measurement as desired.
If the display timing is set to REAL, the time for continuous measurement becomes long because
the screen is updated every time measurement is performed.
If it is set to AFTER to give priority to the measurement time, the screen update time becomes
short. (This is because the screen is updated once after all measurements are complete.)
The default setting is REAL.
Screen display method (For more information, see p. 24):
(Measurement screen) SET key>(SET screen) ADVANCED tab>DRAW key
1
Touch the AFTER key.
REAL Updates the screen after measure-
ment of each panel.
AFTER Displays all after all continuous mea-
surements are nished.
2
Touch the EXIT key twice.
Displays the measurement screen.
4
Using Continuous Measurement Mode