79
Setting Application Settings
3.6 Setting Application Settings
Range synchronization (Setting measurement conditions for individu-
al measurement Ranges)
This section describes how to set measurement conditions for individual measurement ranges.
Basic measurement
conditions (BASIC)
Allows you to set the following measurement conditions for individual
measurement ranges:
• Measurement speed (applies to AC measurement)
• Average (applies to AC measurement)
• Trigger delay (applies to both AC and DC measurement)
• Trigger synchronous delay (applies to both AC and DC measurement)
Measurement conditions
for DC measurement (Rdc)
Allows you to set the DC measurement speed and averaging function for
individual measurement ranges.
(1) Turn on the range synchronization function.
Screen display method (For more information, see p. 24):
(Measurement screen) SET key>(SET screen) ADVANCED tab>RNG SYNC key
1
Touch the ON key.
2
Touch the EXIT key.
The instrument will return to the SET
screen.
Set the measurement conditions as described in "(2) Setting measurement conditions on individual
dialog boxes" (p. 80))and "(3) Setting measurement conditions on a single screen" (p. 81).
3
Performing Measurements in LCR Mode
To Next Page
Loading...
